RJ-45 Splitter

If you possess multiple computers at home or at work, more likely you will want to share the internet connection between all the PC's so that all the users can use the internet at the same time. For this purpose you can employ an ethernet splitter to construct a set of connections where all the PC's can be linked to utilize the internet connection. So the network is simply all the computers linked by a communications device which allows communicating resources between all the users.

If it is not easy for you to get an Ethernet splitter, then you can read this article to understand how you can make one by yourself. But it requires time, patience and a little knowledge of wiring. By setting up an Ethernet splitter, you will be able to connect two or more PC's simultaneously on one Ethernet device.

In order to make your own Ethernet splitters you will need some devices and tools such as two RJ45 Crimpable Plug, four RJ-45 keystone jack, a small Ethernet Cable Scrap approximately 2 feet in length and tools like a RJ45 Crimp Tool Craft knife, 110 Punch Down Mechanism, Loctite  Super Glue. initially you will need to crease the RJ45 Plug to the Ethernet cable. For this to be done you will need to read a configuration scheme taken from a hardware book or from the directions on the package.

Now use the 110 Punch Down Mechanism to press down the other end to the RJ-45 keystone jacks and use the other end of the cable and cut it to 9 inches and press down the four pairs with this wiring code, Jack #1: 1 White/Orange to pin 1keystone jack 2 Orange to pin 2 keystone jack 3 White/Green to pin 3 keystone jack 6 Green to pin 6 keystone jack #2: 4 Blue to pin 2 keystone jack 5 White/Blue to pin 1 keystone jack 7 White/Brown to pin.

Use the preceding instructions to make one more splitter so you eventually have two splitters. Plug one splitter to the RJ45 wall plate and plug the two PC's to the splitter. Now connect the other splitter to the patch plate and plug two patch cables from the splitter to two free Ethernet cables from the switch. If your splitter connections are right then the two links from the knob on which the patch cable are joint should turn on. After this setup is complete, then you will be able to install two PC systems all at the same time connected using only one Ethernet cord. This method is similar to Power over Ethernet but instead of injecting DC, it is injecting another data. It is better if you can to draw one more Ethernet cord from the patch panel to the wall plate. Once you use these guidelines then you should create a successful Ethernet splitter, if not you will need to start over the procedure all over again.

Screenshoot: